Low Gloss

LG Low Gloss sealer is a low-gloss, color-enhancing paver sealer that stabilizes joint sand and protects against sand washout, weed growth and ant infestation. It extends paver life while providing an attractive surface sheen.

  • Low-gloss finish, color enhancing
  • Stabilizes joint sand from washout, weeds & ants
  • Minimizes salt and freeze/thaw damage
  • Provides UV protection
  • Interior/Exterior

Interested? Call, Contact, or Visit Us today.


  • Concrete Pavers



  • Wait 28 days after installing polymeric sand before sealing.
  • Thoroughly sweep surface of joint sand or loose material.
  • Spot clean if needed with one of these SRW cleaning products:
    • CDX = Cleaner & Degreaser X-treme for oil and grease spots
    • RE = Rust Eliminator for rust and mineral removal
  • Prepare all pavers with one of these SRW cleaning products:
    • EF = for Efflorescence removal
    • PW = Paver Wash for general cleaning & polyhaze removal.


  • After cleaning, wait at least 24 hours before sealing. Surface and joints must be completely dry.
  • Recommended application temperatures are 50°F-80°F (10°C-27°) from installation through the cure process.
  • Do not apply if inclement weather is forecasted within 24 hours


  • Apply with an SRW Products approved Slit Foam Roller and sprayer.
  • Spray then back roll. This prevents an uneven finish. A 2-person application is recommended.
  • Always spray against a wet edge and do not overlap a previously sealed and dried area.
  • Start at the highest project eleveation
  • Do not allow sealer to pool on pavers or in joints.
  • Repeat if desired.


  • Allow sealed area to dry and cure 24 hours.
  • Protect area from water and rain until dry.
  • Dry-tack free: 25 minutes
  • Foot traffic: 24 hours
  • Vehicle traffic: 72 hours

Note all calculations based on 68°F-77°F (20°C-25°C)


Safety Data Sheet (SDS) Safety Data Sheet CARB (SDS)