High Gloss

APPLICATIONS

• Concrete Pavers

CLEAN

• Wait 28 days after installing polymeric sand before sealing.
• Thoroughly sweep surface of joint sand or loose material.
• Spot clean if needed with one of these SRW cleaning products:
  • CDX = Cleaner & Degreaser X-treme for oil and grease spots
  • RE = Rust Eliminator for rust and mineral removal
• Prepare all pavers with one of these SRW cleaning products:
  • EF = for Efflorescence removal
  • PW = Paver Wash for general cleaning & polyhaze removal.

CLIMATE

• After cleaning, wait at least 24 hours before sealing. Surface and joints must be completely dry.
• Recommended application temperatures are 50°F-80°F (10°C-27°) from installation through the cure process.
• Do not apply if inclement weather is forecasted within 24 hours

APPLY

• STIR THOROUGHLY
• Apply with an SRW Products approved Slit Foam Roller and sprayer.
• Spray then back roll. This prevents an uneven finish. A 2-person application is recommended.
• Always spray against a wet edge and do not overlap a previously sealed and dried area.
• Start at the highest project eleveation
• Do not allow sealer to pool on pavers or in joints.
• Repeat if desired.

CURE

• Allow sealed area to dry and cure 24 hours.
• Protect area from water and rain until dry.
• Dry-tack free: 25 minutes
• Foot traffic: 24 hours
• Vehicle traffic: 72 hours

Note all calculations based on 68°F-77°F (20°C-25°C)